I've added if_ale_load=”YES" and if_rl_load=”YES" and if_dc_load=”YES" to the. I've added ="1000000" to the systems tuneables. From there, I extracted the 4 NIC drivers from the ISO's boot/kernel folder (if_em.ko & if_alc.ko & if_dc.ko & if_rl.ko).įrom there, I enabled the SSH Secure Shell in the pfSense advanced options, and then connected with WINSCP and copied the drivers into the pfSense boot/kernel folder. iso of FreeBSD 10.1 off of their website. The Intel NIC Chipset and the specific NIC is support on FreeBSD 10.1 em driver as seen here () The Intel NIC was purchased from here () and here are the official Intel specs (). My attempt to fix the Intel NIC, as well as the other NICs, is by adding the drivers and changing settings. I've added the "pass" rule to the Firewall rules section for each NIC as well but that doesn't seem to help. If I plug a computer into any of the Intel NIC ports other than the official LAN port, I get LED activity on the back and the laptop gets all the DHCP information but I am unable to get to the webconfig through any other port. I then added all of the NICs into a bridge (excluded the on-board as it's my WAN) so that they'll get IPs from the LAN (em1). This is all well and good but not all the ports on my Intel PRO/1000 PT Quad Port NIC are working I assign them all in the interface tab and activate them all. I connected an Ethernet to it and it obtained an IP so I'm assuming it's working. The on-board NIC (ale0) seems to work fine though I haven't put it through any particular testing yet. On a rare occasion the 2 NICs will activate their activity LEDs briefly but nothing happens. I assign the On-Board (ale0) to the WAN port.Īctivating the last 2 NICs (Realtek and Atheros) in the interface is possible, but when you plug an Ethernet into either one of them, nothing lights up and there is no LED activity on the NIC or what it's connected to.
PfSense recognizes all 4 of the NICs, even without drivers. I must use the second port on the Intel NIC to get to the webconfig (which is already weird why not the first port?). pfSense sets my WAN to em0 and my LAN to em1. Upon initial install, pfSense will load accordingly with no issues. NIC #2: Intel PRO/1000 PT Quad Port Low Profile Server Adapter (Shows up as em0 through em3) NIC On-Board: Atheros AR8121/AR8113/AR8114 (Not 100% sure which - Shows up as ale0) I apologize in advance for the LONG post.ĬPU: Intel Pentium E5200 Dual-Core ASUS P5KPL-AM EPU This is my first time running an installation of pfSense.
0 kommentar(er)
